Replaces Model Number: Toyota 86790-34011, 86790-34030

**WARNING**: This will NOT fit if your part number is 86-790-34010. Check with your dealer your exact part number prior to ordering.

For use with:

• Toyota Tundra (2007-2013)
   

This is an aftermarket backup camera, not OEM. This camera will plug into your existing wire harness. If your vehicle currently does NOT have a backup camera system, this camera will not work. Double Check your part number prior to ordering.

Camera Specs:

• Sensor: ¼” On-Semi (USA) CMOS Active Pixel Array, Lens: Nidec (Japan) (Glass + Plastic)
• Minimum Illumination : .1 Lux light sensitivity
• Signal System : NTSC/PAL
• Effective Pixel : 728 x 582
• Electronic Shutter : 1/50 to 1/100,000 seconds
• Resolution : 600 TV lines
• Angle : 170 Degrees
• Waterproof Rate : IP68
• Power : DC 6v-12v
• Video Cable: 40.5 inches

**ATTENTION: Before purchasing, make sure to verify that your part number is an EXACT MATCH to this part number*
[For use with]: Toyota Tundra (2007 2008 2009 2010 2011 2012 2013) OE Part # 86790-34011 (8679034011), 86790-34030 (8679034030), [WARNING] This will NOT fit if your part number is 86-790-34010. Check with your dealer for your exact part number prior to ordering.
[Camera]: Wide angles up to 168°(Diagonal) + 100°(Vertical) + 136°(Horizontal); Designed for low light to .1lux
[Specs] Up to 800TVL; Waterproof to IP69K; Safe working temp from -104F to 220F. Japanese Nidec Lens, OnSemi USA Chip
[Plug and Play]: Plugs into Existing OEM Video Harness, no programming required