What size is the exhaust cutout?

The burnout cutout is sized for a centered dual or single exhaust outlet. Measure your exhaust piping diameter and tailpipe exit position before final trimming—you may need to enlarge or adjust the opening slightly to match your specific setup.

Will this fit with my factory rear sensors?

The bumper ships as a blank panel. If your vehicle has rear parking sensors or collision detection mounted in the OEM bumper, you'll need to drill matching holes or relocate the sensors to the new cover. Reference your vehicle's OEM bumper hole locations and sensor specifications before installation to ensure proper placement.

Should I prime and paint before installing?

You can install first and finish after, or sand, prime, and paint off the vehicle for cleaner results. Since the bumper ships raw FRP, light sanding with 400-grit or higher prep work before your chosen finish will ensure proper adhesion and a clean final appearance.