Will these panels interfere with jack point access?

Check your vehicle's jack point location before final installation. If the factory jack pad sits directly under the skirt area, you may need to trim or route around it. Reference your owner's manual for exact jack point placement, then test-fit the panel to confirm clearance.

What prep work is needed before painting?

Sand and prep the surface with standard automotive sandpaper, then clean thoroughly to remove all dust. Apply your chosen primer and paint system per the manufacturer's instructions. FRP accepts both single-stage and multi-stage finishes once the surface is properly prepared.

What fastening method should I use for installation?

Determine your mounting points by dry-fitting the panels against the rocker panel. Most installations use self-tapping fasteners or adhesive-backed clips, but your specific choice depends on the panel geometry and your preference. Test-fit first to confirm the best approach for your setup.