Will this cover my OEM fog light cutouts, or do I need to trim them out?

The Strake design integrates with most fog light openings, but you'll want to test-fit and verify alignment with your bumper mounting points before committing to paint. Compare the cover's opening position to your vehicle's OEM setup to confirm no additional cutting is necessary.

Does this bumper work with factory parking sensors?

This is a cover assembly only — it does not include sensor integration. If your vehicle has OEM parking sensors in the bumper, you'll need to either relocate them or ensure the mounting bracket clears the new cover's interior geometry. Measure your sensor location against the two-piece layout before installation.

How should I prep the surface before primer and paint?

Sand the FRP with appropriate abrasive to open the gelcoat surface, then clean thoroughly to remove dust and release agents. Once prepped, apply your chosen primer and topcoat system. The two-piece design allows you to finish each section separately if desired, which can simplify the painting workflow.