• Additional protection
• Various flag designs
• Easy to apply
• Installation video below
• Dash letters sold separately

2021+ Bronco American Flag Dash

Show off your pride right on your dash.  We have an assortment of flag designs so you can show off you whatever you stand for and / or take pride in.

Currently fits ALL 2021+ Broncos.  Matte finish.  Dash letters are trademarked and not available or included.

Features

• TruProtect - UV Resistant Laminate
• TruPrint - Authentic Roland inks and printers
• Made in the USA

NOTE:  We took into consideration airbag deployment and pre-cut the material in this area so it can break free should your passenger airbag deploy.  You will notice a slight cut line in this area, but the material is still intact to make the install easy.  

Customization

While StickerFab caters to a large number of people, it is still possible to customize some orders.  Ideas that have broad appeal are the best!  However, if you have some art work, we may be able to do a special print just for you.

• Military Themed
• Patriotic
• Other organizations

Please refrain from submitting trademarked content unless you have the rights to it.  We are located in Fort Myers, FL if you are interested in helping us create custom templates for other vehicles or trim levels.

Use our contact form to get in touch with us.

INSTALLATION

This install is fairly simple and straightforward.  Just make sure you align the cutout first and go from there.  Follow the installation video above and read these directions please.  NOTE:  All topo vinyls are shipped in tubes to prevent damage.  Prior to install, lay out all of these items and make sure they are flat prior to install.

You will want to do this in 70-80 degree weather ideally.  Stay in the shade unless it is a little on the cool side.   You may elect to do this install after a drive to get the interior temperature in the target area.  If your vehicle is running please make sure you are in a well ventilated area.

Recommended items:

• This Kit (overlays)
• Microfiber
• Detailer spray or interior cleaner to prep the area (without wax)
• Alcohol wipe (optional)
• StickerFab Application Fluid (or one drop of dish soap mixed with 1 cup of water)
• Felt tip squeegee
• Optional Heat gun or hair dryer

Prep by cleaning them thoroughly.  You can use isopropyl alcohol, however if it is cold or humid, please wait a few minutes to make sure that they area is dry.

We recommend a wet install.  Clean your hands as you will be touching the back of the vinyl a little.

Spray the application area and the back of the vinyl with your fluid.  Once the alignment is correct, push out the air and fluid with your fingers.  Use firm pressure to activate adhesive for the final pass.   For trouble spots and a final pass, use your squeegee.  If it is cooler outside, use heat to activate the adhesive as well.

Sometimes you will have to wait for the edges to be able to adhere due to the use of application fluid.  You can speed up the drying process with LIGHT heat.