Do I need any additional hardware to install this?

Check your vehicle's service manual for the fastener specification at the factory brake light location. The assembly mounts at existing OEM anchor points — additional hardware depends on the condition of your current mounting tabs.

Will this work as a direct bolt-in replacement?

Yes. This LED unit is designed to sit at the factory brake light position without drilling or bodywork. Test-fit before final installation to confirm proper alignment with your Cube's rear panel.

Does this require any wiring changes?

Wiring compatibility depends on your specific vehicle's electrical connector type. LED brake lights sometimes require load resistors or decoder modules if your Cube uses CAN-bus diagnostics — consult your service manual or a qualified tech before purchasing if you're unsure about your vehicle's brake light circuit.