Do I need to drill new holes for sensors or parking aids?

The 2-piece design aligns with factory mounting points on the rear fascia. Before installation, reference your vehicle's OEM bumper to identify existing sensor and harness locations, then mark and drill cutouts as needed to match your specific setup.

What prep work is required before I paint?

Sand the raw FRP gelcoat surface to create adhesion for your base coat and clear. Once the surface is smooth and primed, your paint system will bond properly and cure without lifting or peeling.

Will this interfere with my exhaust or diffuser?

The Tecnika styling maintains the OEM exhaust outlet positioning and does not extend further rearward than the factory bumper. If you run an aftermarket diffuser, confirm the mounting bracket clears the 2-piece seam line at the center where the two halves meet.