Do I need to prep and paint each piece separately before installation?

Yes. Sand and prep the surface of each piece before applying your chosen finish. Most builders paint the bumpers and skirts off the vehicle for even coverage and easier masking, then install once fully cured. This approach avoids overspray on adjacent panels and ensures consistent color across all four pieces.

Will this kit work with existing fog lights and sensors?

The bumper design accommodates factory fog hole locations. Before installation, verify your vehicle's OEM bumper hole sizes and sensor cutout positions against the new bumper openings. Minor trimming may be necessary depending on specific sensor placement, so test-fit before final assembly.

Do I lose access to the jack points with the side skirts installed?

Check jack point clearance on your vehicle before final installation. The skirt profile is designed to sit above factory jack locations, but your specific vehicle geometry should be confirmed. If clearance is tight, mark and test your jack lift points with the skirts loosely fitted to ensure safe access.